Description

dsPIC 30F3010 High-Performance,16-Bit Digital Signal Controllers This is a 28 pin high performance 1- bit dsPIC series Micro-controller from Microchip. Features of dsPIC30F3010 High-Performance Modified RISC CPU Modified Harvard architecture C compiler optimized instruction set architecture 84 base instructions with flexible addressing modes 24-bit wide instructions, 16-bit wide data path 16 x 16-bit working register array Up to 30 MIPs operation DC to 40 MHz external clock input 4 MHz-10 MHz oscillator input with PLL active (4x, 8x, 16x) Peripheral and External interrupt sources 8 user selectable priority levels for each interrupt 4 processor exceptions and software traps Primary and Alternate interrupt Vector Tables dsPIC30F3010 Engine Features Modulo and Bit-Reversed Addressing modes Two, 40-bit wide accumulators with optional saturation logic 17-bit x 17-bit single cycle hardware fractional/ integer multiplier Single cycle Multiply-Accumulate (MAC) operation 40-stage Barrel Shifter Dual data fetch dsPIC30F3010 Peripheral Features High current sink/source I/O pins: 25 mA/25 mA Optionally pair up 16-bit timers into 32-bit timer modules 3-wire SPI™ modules (supports 4 Frame modes) I2C™ module supports Multi-Master/Slave mode and 7-bit/10-bit addressing Addressable UART modules with FIFO buffers Motor Control PWM Module Features Complementary or Independent Output modes Edge and Center Aligned modes Multiple duty cycle generators Dedicated time base with 4 modes Programmable output polarity Dead time control for Complementary mode Manual output control Trigger for synchronized A/D conversions Quadrature Encoder Interface Module Features Phase A, Phase B and Index Pulse input 16-bit up/down position counter Count direction status Position Measurement (x2 and x4) mode Programmable digital noise filters on inputs Alternate 16-bit Timer/Counter mode Interrupt on position counter rollover/underflow Analog Features of dsPIC30F3010 10-bit 1 Msps Analog-to-Digital Converter (A/D) A/D Conversion available during Sleep and Idle 4 Sample/Hold Channels Multiple Conversion Sequencing Options Special Microcontroller Features Enhanced Flash program memory: 10,000 erase/write cycle (min.) for industrial temperature range, 100K (typical) Data EEPROM memory: 100,000 erase/write cycle (min.) for industrial temperature range, 1M (typical) Self-re-programmable under software control Power-on Reset (POR), Power-up Timer (PWRT) and Oscillator Start-up Timer (OST) Flexible Watchdog Timer (WDT) with on-chip low power RC oscillator for reliable operation Fail-Safe clock monitor operation Detects clock failure and switches to on-chip low power RC oscillator Programmable code protection In-Circuit Serial Programming™ (ICSP™) Programmable Brown-out Detection and Reset generation Selectable Power Management modes Sleep, Idle and Alternate Clock modes CMOS Technology Low power, high speed Flash technology Wide operating voltage range (2.5V to 5.5V) Industrial and Extended temperature ranges Low power consumption